The CO2 incubator is widely used, and it is also a very popular product in the market due to its various advantages. But it also has a lot of knowledge points that need to be understood when using it. After all, there are still many users who do not understand these. Next, the editor will introduce the working principle of the CO2 incubator for everyone? If you are interested, you can read it.

　　The CO2 incubator is actually an advanced instrument for cell, tissue and bacterial culture. The CO2 incubator is mainly used when it is in use. It is improved on the basis of ordinary cultivation, mainly by adding to meet the environment required for cultivating microorganisms. The CO2 incubator is controlled by a concentration sensor. In short, everyone should know that it is used to detect the concentration in the tank, and transmit the detection results to control devices such as control circuits and solenoid valves. If it is detected that the inside of the box is low, the solenoid valve is opened, and at this time, it enters the box. Until the set concentration is reached, the solenoid valve is closed, the box is powered off, and a steady state is reached. Its sampler samples the gas mixed with air in the box to the sampling port on the outer panel of the machine, so that the concentration analyzer can be used to detect whether it meets the requirements at any time. Most produce moisture through evaporation from the humidifying pan.

　　Of course, this is mainly because the larger the humidity evaporation area, the easier it is to reach a larger relative saturated humidity, and the shorter the time for humidity recovery after opening and closing the door. Therefore, a CO2 incubator with a large humidity evaporation area is easier to maintain a larger relative saturated humidity than an incubator with a small humidity evaporation area. The liner of the CO2 incubator is made of mirror stainless steel or brushed plate argon arc welding, and the four corners are semicircular, which is easy to clean. Microcomputer temperature controller, small temperature fluctuation. The box is equipped with ultraviolet germicidal lamps, and the box is regularly disinfected to more effectively prevent pollution during the cell culture process. Of course, there are also some temperature alarm systems, which will be automatically interrupted when the temperature exceeds the limit, so as to ensure the safe operation of the experiment without accidents (optional). Manufacturers also use door temperature control when producing CO2 incubators , which can effectively prevent condensation on the glass door inside the box. Its water jacket is equipped with a microbial filter located in the air inlet, which provides filtered gas. As the main product of our factory, we would like to thank new and old customers for their strong support. While ensuring the reliability of product quality, we will benefit our customers. If you have any technical questions about products, you can come here for consultation at any time. .

　　After the introduction of the above content, we also have a further understanding of the working principle of the CO2 incubator. When you see him again in the future, you won't feel unfamiliar, and there won't be frequent problems in the process of using it. Well, that's all for today's content, I believe it will bring more exciting knowledge points.